Thingiverse
Shower
von makehacktech
74
Downloads
78
Likes
0
Makes
A model of a shower for doll house play.
The model is a bit shorter than the one shown in the picture.
Print the base with flat side down, the back with the back side down, both with no supports. Print 2 x taps with handles up with supports.
For assembly, I glued the back down into the slots on the base and glued the taps into their holes.
I printed at 0.16 resolution.
The model is a bit shorter than the one shown in the picture.
Print the base with flat side down, the back with the back side down, both with no supports. Print 2 x taps with handles up with supports.
For assembly, I glued the back down into the slots on the base and glued the taps into their holes.
I printed at 0.16 resolution.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
