Thingiverse
Side Panel / Bed re-wire 2
von Eta232
23
Downloads
5
Likes
0
Makes
Its an remix of thing: https://www.thingiverse.com/thing:1864625
and this one: https://www.thingiverse.com/thing:2451362
Print with PLA, with your working settings. I used an glass bed at 60°C with gllue stick.
Use support for the hole for cables. I used 4 skirt lines to prime the nozzle. It will fit for an 6mm linear rod.
and this one: https://www.thingiverse.com/thing:2451362
Print with PLA, with your working settings. I used an glass bed at 60°C with gllue stick.
Use support for the hole for cables. I used 4 skirt lines to prime the nozzle. It will fit for an 6mm linear rod.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!