Thingiverse
Side Table Legs
von scottyujan
62
Downloads
86
Likes
0
Makes
More details in this video: https://youtu.be/iJEq-vBG1Ws
I had a bit of an issue with bed adhesion so I made two versions, one with a brim and one without. I printed these with a .8mm nozzle and it took about 11 hours per leg.
The one with the brim is also designed to be printed at a slight 25-degree rotation flat on the bed. This allows each layer to be at its maximum length across the leg which in theory would result in a stronger print. I definitely recommend this if you're going to put heavy weight on this table like... I did in the video.
CR-30
PLA
15% infill
2.4mm wall thickness
I had a bit of an issue with bed adhesion so I made two versions, one with a brim and one without. I printed these with a .8mm nozzle and it took about 11 hours per leg.
The one with the brim is also designed to be printed at a slight 25-degree rotation flat on the bed. This allows each layer to be at its maximum length across the leg which in theory would result in a stronger print. I definitely recommend this if you're going to put heavy weight on this table like... I did in the video.
CR-30
PLA
15% infill
2.4mm wall thickness
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
