Side Table Remote Holder Mount

This is a remote stand mount that screws in on the underside of the table top. Allowing a seamless mounting experience. I personally do not care if I screw into the bottom side of the table, but you can always use mounting tape as well and get similar results. I have designed this mount to fit a variety of remotes. Printed in PLA, but nearly any sturdy filament should do the trick.My Mounting ScenarioScrews I used were 4mm in diameter and about 16mm in length. The mounting holes have a stand off of 7mm (Table top thickness was 19mm). Remote slot sizesFirst 2 remote slots: 25mmx40mmThird remote slot: 25mmx60mm These slots should be good for most modern and possibly universal remote controls in a living room setting. Please check your own measurements before printing. Thank you and feel free to comment with any suggestions or requests for future models I can create!