Thingiverse
Signal Hound stack
von IU1LCU
0
Downloads
1
Likes
1
Makes
A simply stack bracket to keep together the signal hound SA44B and TG44A
In the middle there are two 6,5mm holes for two screws to tighten on the sides.
I will keep these as "Work in progress" till i will print and test it
In the middle there are two 6,5mm holes for two screws to tighten on the sides.
I will keep these as "Work in progress" till i will print and test it
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
