Silverware Tray

This is a silverware tray I made for our house. We keep living in places with very narrow kitchen drawers, so I finally came up with a compact design that can hold all of our standard silverware, with room for chopsticks too. This was designed around our IKEA silverware, but should be able to fit other designs as well.

Because of the length of the finished piece, I broke it down into two separate blocks, with a couple of makeshift tabs to connect the two. The main blocks are designed to be printed vertically, while the tabs are printed horizontally. One could print all the pieces at the same time, but it would take quite a while.

Dimensions are 290mm x 173mm x 60mm for the full piece. The longer of the two pieces is 160mm long.