Thingiverse
Sim Racing Sequential Shifter
von vonhellsing
4
Downloads
2
Likes
0
Makes
PARTS I USED
2x - V155 Micro Switch
1x - USB Joystick Encoder
2x-6x - Springs They need to be atleast 5mm in Outer-Diameter and atleast 20mm long.
1x - 80mm M10 Hex Bolt (Lever Joint)
4x - 20mm M3 Screws (Micro Switches)
2x - 35mm M5 Countersunk Screws (Springs)
1x - 60mm M5 Hex Bolt (Knob)
4x - 30mm M6 Cap Head Screws (Base)
1x - ~1m Wire (I just got an old USB cable and cut it to length.)
1x - ~ 30cm Heatshrink (Optional but makes it cleaner.)
2x - V155 Micro Switch
1x - USB Joystick Encoder
2x-6x - Springs They need to be atleast 5mm in Outer-Diameter and atleast 20mm long.
1x - 80mm M10 Hex Bolt (Lever Joint)
4x - 20mm M3 Screws (Micro Switches)
2x - 35mm M5 Countersunk Screws (Springs)
1x - 60mm M5 Hex Bolt (Knob)
4x - 30mm M6 Cap Head Screws (Base)
1x - ~1m Wire (I just got an old USB cable and cut it to length.)
1x - ~ 30cm Heatshrink (Optional but makes it cleaner.)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
