Thingiverse
Simple base/riser for figures
von kuts
0
Downloads
1
Likes
0
Makes
Simple base/riser, mainly anime figures.
The legs provided are 20mm or 2cm, but you can scale them to your desired lenght just remember that the base by itself adds 3mm or 5mm (depending on the base used) to the total lenght. (Eg. legs 2cm + 0.3cm of the base or 2cm + 0.5mm of the base.)
Tested with 1/6(310mm) scale fig.
The legs provided are 20mm or 2cm, but you can scale them to your desired lenght just remember that the base by itself adds 3mm or 5mm (depending on the base used) to the total lenght. (Eg. legs 2cm + 0.3cm of the base or 2cm + 0.5mm of the base.)
Tested with 1/6(310mm) scale fig.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
