Thingiverse
Simple Cap Wall Hook
von RandoEG
8
Downloads
3
Likes
0
Makes
Very simple wall hook for caps. The hole accommodates 2.5 mm screws.
_____
**All of my designs have roughly a 0.1 to 0.3 mm offset/compensation for things to fit together** according to how my printer prints. I have no idea if this is a universal problem or not.
**Supports on my designs are always minimal if not nonexistent.** Here there is none needed. **But I highly recommend a 1 layer raft.**
_____
**All of my designs have roughly a 0.1 to 0.3 mm offset/compensation for things to fit together** according to how my printer prints. I have no idea if this is a universal problem or not.
**Supports on my designs are always minimal if not nonexistent.** Here there is none needed. **But I highly recommend a 1 layer raft.**
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
