Thingiverse
Simple Drawer
door BostonBowser
13
Downloads
13
Likes
0
Makes
Simple drawer. Uses four flat head #4 1/2 in wood screws and two 1 in drywall screws for the pull. Objects should be in the correct orientation.
Optimized for a 0.8mm nozzle at 0.6mm layer height, but should work fine if multiples of those numbers are used.
Sanding between the contact points may be necessary to get a nice wit with smooth operation. Printed without supports, but the large overhang on the slide would probably benefit from a single support in the middle if bridging is a concern.
Step file has been included.
Optimized for a 0.8mm nozzle at 0.6mm layer height, but should work fine if multiples of those numbers are used.
Sanding between the contact points may be necessary to get a nice wit with smooth operation. Printed without supports, but the large overhang on the slide would probably benefit from a single support in the middle if bridging is a concern.
Step file has been included.
BostonBowser publiceert ook op
2 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
