Thingiverse
Simple Face Shield
von BillsMafia
19
Downloads
10
Likes
1
Makes
## **If located in the DC metro area please consider joining our [Reddit group](https://www.reddit.com/r/DCArea3DPrinting/) if you'd like to contribute!**
This is a simple face shield that I am using to donate to local medical facilities in the DC, Maryland, & Virginia area. Each face shield takes about 1hr to print and can be stacked w/ supports between objects.
### **EDIT 4/6:**
Added Simple Face Shield 2.0 on recommendation from the DC organizer. We are migrating to this file as of today. I also added a 4 stack file with 0.28mm between each model. This removes the need for supports between models while still making them very easy to separate. I was able to print the 4stack_SFS2_v1 file in about 3.5 hrs.
### **EDIT 4/3:**
Added 4 stack v2 (4stack_SFS_v2.stl). Decreased the height between models by 0.6mm and increased layer height to 0.28 among other edited settings to reduce overall printing time. Printer ran around 78mm/s speed and had the 4-stack done in 4 hrs and
This is a simple face shield that I am using to donate to local medical facilities in the DC, Maryland, & Virginia area. Each face shield takes about 1hr to print and can be stacked w/ supports between objects.
### **EDIT 4/6:**
Added Simple Face Shield 2.0 on recommendation from the DC organizer. We are migrating to this file as of today. I also added a 4 stack file with 0.28mm between each model. This removes the need for supports between models while still making them very easy to separate. I was able to print the 4stack_SFS2_v1 file in about 3.5 hrs.
### **EDIT 4/3:**
Added 4 stack v2 (4stack_SFS_v2.stl). Decreased the height between models by 0.6mm and increased layer height to 0.28 among other edited settings to reduce overall printing time. Printer ran around 78mm/s speed and had the 4-stack done in 4 hrs and
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
