Simple GPU Support - Remix

I re-made it implementing the following changes:

1. Fixed split in stand (mentioned a few times in original design's comments);
2. Made lock nut sligtly bigger and added notches;
3. Adjusted thread tolerance so it is not too lose now;
4. Added spacers (black on photos) that can be glued with double sided tape (white on photos) to case and GPU so the stand will not slide off;
5. Changed sizes so the support can be adjusted from 83mm (no nut, no spacers) up to 144 (two spacers);
6. STEP & OrcaSlicer project (3mf) files published.

**10/01/2026**
Short version added. It can be adjusted from 53mm (no nut, no spacers) up to 86mm (two spacers). Thread is the same, but bolt and stand are shorter and lock nut and spacers are thinner.