simple led light custom name

This is a 3d printed light with the option to add your name on the side you probably have to grind of a little based on your led model and your printer the fit in the "tappo f" piece for the led it would have a little friction not a loose fit. For the build You will need: 2 led any color; resistor 60 Ω ( if you use yellow, green or red leds if you use like me white or blue leds you don't need it, also optional with the use of a button battery); Battery u can use a button battery or any tipe that has a nominal voltage around 3.7 volts; Battery connector inside there is a small box to insert it ( OPTIONAL IF YOU USE A BUTTON BATTERY); microswitch I used one from an old circuit but it is similar to some end point switches; 2 wires anything between 22 and 32 gauges will be okay but a smaller wire will make it easier to install. To begin you have to start building the circuit like the scheme here, then when you have printed all the parts you will have to insert from the front of the "corpo c" part see image n.4 the microswitch on the side being careful to pass the wires in the back, then you insert the batter connector if you need one in his place image n.5 finally you insert the leds in the "tappo f" part and insert it in the front it will click in place; finally in the back you connect the battery and before closing up You add the "tasto" piece and push it in until you see a square in the hole in witch you insert the "testa tasto piece" (you may need a little superglue) finally you can close the light back with the last piece "tappo f". if you like to add your name you have the fusion 360 extensions and the step files, the print profile is blank and the files with s n are blank too the other have my name on them but you can change it very easily by changing the name in fusion file or in the step substitute mine with other by engraving another one and extruding out mine.