Simple panorama bracket

Simple panorama bracket to help make panoramic or wide angle photos (high resolution photos).
Requires tripod head with rotating base.

Designed to be simple and easy to print - so don't expect advanced functionalities.

Version A of Side and Upper parts have pitch angles -45 - 0 - +45 degrees (I use it for wide landscapes with 18mm lenson 1.5x crop dSLR). Version B has pitch angle every 10 degrees.
Pitch angle is limited by construction - it's not designed to make full sphere panoramas without wide angle lens.

Print screws separately (best thread quality), with very high infill. Should work with 100% scale printing - just screw in and out a few times and then lube with something that will not eat plastic (mineral oil should be safe).

Hardware required:
- 1/4"-20 to 3/8"-16 Reducer Bushing for Base RB
or 1/4" hex nut for Base Hex (glue it in with epoxy)
- 1/4"-20 screw with 25mm thread

Warning! Secure your camera with a strap in case of any part failure!