Thingiverse
Simple PCB vice
von Nickademusss
5
Downloads
3
Likes
0
Makes
This is a customisable width PCB vice, made using your choice of length 1/4X20 all thread and nuts.
I printed with 30% infill in PLA+
The rods are ar bolted to one jaw and the other get screwed down my the thumb screws. Its strong enough to bend circuit boards so dont over tighten.
I printed with 30% infill in PLA+
The rods are ar bolted to one jaw and the other get screwed down my the thumb screws. Its strong enough to bend circuit boards so dont over tighten.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
