Simple Quad Design

Quick design i made for a quadcopter that uses 13x13x150mm hollow aluminium arms, a 4 in 1 speed controller, and one of the naze32 boards (30.5mm x 30.5mm). The leads from the motors are meant to go through the arms but are a little tricky to get connected. Its defiantly something ill work on in the future but for now i'm just going to solder the motors straight to the ESC.

Also it should be noted that I've never built a quad before so who knows how well this will even work. if you made the arms shorter you could probably get something better at acro, but i was going for a more stable quad here (i believe the prop/ motor combo i got were DJI clones.)

Hardware:
M3x8 16
M3x25 4
M3 Nuts 20
M4x45* 4
M4 Nuts 4
M5x17 1
M5 Nut 1
Velcrostrap for battery

*if you don't want the top piece which is just meant for extra gear (VTx and GPS in my case) you only need a M4x25. You can also change the height for the standoffs if you want