Thingiverse
Simple Raspberry Pi Base
door miekush
4
Downloads
1
Likes
0
Makes
This is a super simple platform/base for Raspberry Pi boards. I included a normal base for just the Pi and another for attaching a Pi Camera.
In addition to your Pi, you will also need the following:
(4) M2.5 screws
If you are using the Pi/Camera base, you will also need the following:
(4) M2 screws
Supports are not needed for the normal base but are required for the camera base
To prevent the base from sliding around, I also like to add some rubber feet to the bottom. See below link to purchase.
https://www.amazon.com/Cabinet-Bumpers-Adhesive-Cupboards-Furniture/dp/B0B8RX77TG/ref=sr_1_32?crid=3TUYARXMWTC6B&keywords=rubber+feet+3m&qid=1666536752&qu=eyJxc2MiOiI0LjIzIiwicXNhIjoiMy45OCIsInFzcCI6IjMuMjcifQ%3D%3D&sprefix=rubber+feet+3m%2Caps%2C97&sr=8-32
In addition to your Pi, you will also need the following:
(4) M2.5 screws
If you are using the Pi/Camera base, you will also need the following:
(4) M2 screws
Supports are not needed for the normal base but are required for the camera base
To prevent the base from sliding around, I also like to add some rubber feet to the bottom. See below link to purchase.
https://www.amazon.com/Cabinet-Bumpers-Adhesive-Cupboards-Furniture/dp/B0B8RX77TG/ref=sr_1_32?crid=3TUYARXMWTC6B&keywords=rubber+feet+3m&qid=1666536752&qu=eyJxc2MiOiI0LjIzIiwicXNhIjoiMy45OCIsInFzcCI6IjMuMjcifQ%3D%3D&sprefix=rubber+feet+3m%2Caps%2C97&sr=8-32
miekush publiceert ook op
18 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
