Simple Raspberry Pi bumper

A simple minimalistic Raspberry Pi bumper (models 2 & 3 B IIRC) I made to have the pi's a little more protected. Atm there's a bare-bones version, a raspi cam version (with a slot to accommodate the cam ribbon), a version that allows access to the pins, and a cam version of same. Just pick the top you like and snap to the bottom.

Designed to be printed at 0.2 mm and snapped together.

edit: original btm was about half a mm short up front, new model uploaded.

edit: if you got an anycubic kossel, there's a clip here -> https://www.thingiverse.com/thing:3390812 that allows this bumper to be clipped to the frame.

edit: as promised, versions that allow access to the pins added.

edit: For a 'case' version of this, go have a look here: https://www.thingiverse.com/thing:3427999

Also, Pro-tip: when/if disassembling this, use a spudger and remove the bottom - the mating pins are less likely to break that way.