Thingiverse
Simple shelf support peg
von TRyanRogers1
397
Downloads
261
Likes
0
Makes
Super simple shelf support pin/peg for wardrobes, bookshelves, etc. that use pre-drilled holes and pegs to hold up flat board shelving.
Prints with no supports. Consider adding brim.
You may need to do a test print to size my STL file up or down a little if the peg is too loose or tight, respectively.
*NOTE: This is an asymmetric pin, designed to be printed with the largest flat side touching the build plate.*
Prints with no supports. Consider adding brim.
You may need to do a test print to size my STL file up or down a little if the peg is too loose or tight, respectively.
*NOTE: This is an asymmetric pin, designed to be printed with the largest flat side touching the build plate.*
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
