Thingiverse
simple spoke tool.
door eddiema
48
Downloads
30
Likes
1
Makes
A tool to aid fingers in tightening bike spokes nipples.
Most likely you will still use a metal tool for the last turn or two.
My e-bike spokes seem to be non-standard - slightly too big for the size-0 hole in my bike multi-tool thing.
My thing has approximately a 3.6mm square hole (3.7mm in the artwork).
It fits over my 2.3mm gauge 13 spokes. Most spokes are 2mm so you could scale this part up or down quite a bit to suit other nipple sizes.
My tool did one wheel and still looks usable but don't expect it to last forever.
Most likely you will still use a metal tool for the last turn or two.
My e-bike spokes seem to be non-standard - slightly too big for the size-0 hole in my bike multi-tool thing.
My thing has approximately a 3.6mm square hole (3.7mm in the artwork).
It fits over my 2.3mm gauge 13 spokes. Most spokes are 2mm so you could scale this part up or down quite a bit to suit other nipple sizes.
My tool did one wheel and still looks usable but don't expect it to last forever.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!