Thingiverse
SIMPLE SPOOL ADAPTER
by Howardson
10
Downloads
9
Likes
0
Makes
After browsing I couldn't find a spool adapter I liked so I designed this one. It's very simple and need NO extra bits i.e. bearings, washers, or nuts.
The OD is 56.5mm or 2.22in (highest measurement I could get after printing was 56.9.)
the length it 75mm or 2.95in.
I recommend printing with the flange touching the bed. Turn OFF supports because you can not get inside to remove them easily. I added a large fillet to the inside to help print the top with little to no stringing.
Fits my Solutech Filament spools, may fit others!
The OD is 56.5mm or 2.22in (highest measurement I could get after printing was 56.9.)
the length it 75mm or 2.95in.
I recommend printing with the flange touching the bed. Turn OFF supports because you can not get inside to remove them easily. I added a large fillet to the inside to help print the top with little to no stringing.
Fits my Solutech Filament spools, may fit others!
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
