Simple Spool Holder

**Simple Spool Holder**

Designed for use somewhere next to your printer. Print in your own colors to tickle your fancy.

Made for 1 Kg spools not exceeding a diameter of 220mm.

No supports needed in any of the prints. Spool holder might need a brim to keep it in place on the printer (was hot day and crappy filament refused to stick)

**Update (2024/03/11)**
- Updated the spool holders and spool screws to screw in lot better without any struggles
- Added a spacer (Due to happy accident)
- Two versions of each spool holders are available
- 80mm will require a spacer on each side. Initially printed spool holder too short and made a spacer and ended up liking it a lot
- 100mm, no spacers required
- Spool screws with a slightly new design and thicker for easier gripping

**Update**
Updated screw added (Small flat extended by 2mm, screw extended by 10mm)
Updated bridge (Extended by 20mm)
Original spool holder removed and replaced with two (Pick your poison)

Origi