Thingiverse
Simple Stacking System
von Urbanist
386
Downloads
349
Likes
2
Makes
Just another stacking container system.
Original size is 50x50x60mm but u should be able to scale it in ur slicer in case needed.
Parts fit tight so make sure ur printer is calibrated.
On the file list CT = Clean Top ; CR = Clean Right and so on...
Edit:
I edited the fittings to be a bit more loose, since connecting single boxes worked well but connecting edges was a little too hard. Now everything should fit a little bit easier.
Let me know how it works for u.
In case u have any suggestions on drawers etc. let me know.
Original size is 50x50x60mm but u should be able to scale it in ur slicer in case needed.
Parts fit tight so make sure ur printer is calibrated.
On the file list CT = Clean Top ; CR = Clean Right and so on...
Edit:
I edited the fittings to be a bit more loose, since connecting single boxes worked well but connecting edges was a little too hard. Now everything should fit a little bit easier.
Let me know how it works for u.
In case u have any suggestions on drawers etc. let me know.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
