Thingiverse
simple Touch Sensor | Bed Leveling Senor
von TueftelTyp
12
Downloads
11
Likes
0
Makes
My plan was to develop a push button sensor for everyone.
Here are used parts that cost almost nothing.
Parts list:
1x tactile switch (6mm x 6mm x 4mm; pin: Ø3,5mm x 4mm )
1x guide rod from CD drive (Ø3mm x ±80mm)
2x cable
3x printed parts
Here are used parts that cost almost nothing.
Parts list:
1x tactile switch (6mm x 6mm x 4mm; pin: Ø3,5mm x 4mm )
1x guide rod from CD drive (Ø3mm x ±80mm)
2x cable
3x printed parts
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
