Thingiverse
simple Towel Holder / Rack
von _die_marille_
6
Downloads
1
Likes
0
Makes
I designed this simple towel holder in order to have a seperate towel in the bathroom. It works perfectly fine and was designed using TinkerCad.
Printing:
- PLA filament was used
- Print speed was set to 50 mm/s
- printing time was roughly 55mins using AnyCubic i3 Mega-S Printer
- Activate Support for the overhang
- If needed, please rotate the model in your slicer so that the thick base is on the print bed
- Infill was set to 50%, although 60 / 70% would also be fine, especially for heavier towels
- I mounted the product on a rather flat wooden surface with some strong double sided tape.
Printing:
- PLA filament was used
- Print speed was set to 50 mm/s
- printing time was roughly 55mins using AnyCubic i3 Mega-S Printer
- Activate Support for the overhang
- If needed, please rotate the model in your slicer so that the thick base is on the print bed
- Infill was set to 50%, although 60 / 70% would also be fine, especially for heavier towels
- I mounted the product on a rather flat wooden surface with some strong double sided tape.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
