Thingiverse
Simplistic Dice Tower
door Johnreinker
12
Downloads
4
Likes
0
Makes
Block supports everywhere but the doorway
Print at 180mm+ on the Z height (uniform scaling) for large die
Print at 120mm+ on the Z height (uniform scaling) for mini die
Prints well with 15% cubic infill
Doesn't need to be printed any finer than .2mm layer height
Should not need any bed adhesion if your printer is dialed in (No brim, raft, etc.)
Print at 180mm+ on the Z height (uniform scaling) for large die
Print at 120mm+ on the Z height (uniform scaling) for mini die
Prints well with 15% cubic infill
Doesn't need to be printed any finer than .2mm layer height
Should not need any bed adhesion if your printer is dialed in (No brim, raft, etc.)
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
