Thingiverse
Single extruder Makerbot replicator leveling post
door wdelarme
3
Downloads
1
Likes
0
Makes
This levels the top piece of the extruder so it doesnt hang down on the one side. I added a nylon washer next to the heated block and the post.
Not sure if it was supposed to come with some thing similar from makerbot but mine looked like crap until I put these on
Not sure if it was supposed to come with some thing similar from makerbot but mine looked like crap until I put these on
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
