Thingiverse
Sink Plug
13
Downloads
6
Likes
0
Makes
Wanted to hand wash our face masks but our bathroom sink did not have any stopper/plug to do so. So into fusion 360 I went to model one. This one has been working great for months. I printed in TPU for a good seal.
The dimensions I modeled it in are the bottom part of the plug has a diameter of 25mm and top part of 33mm. If this does not fit your sink you could probably scale it well in your slicer.
The dimensions I modeled it in are the bottom part of the plug has a diameter of 25mm and top part of 33mm. If this does not fit your sink you could probably scale it well in your slicer.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
