Thingiverse
Ski boot sole
von MTB3D
31
Downloads
24
Likes
0
Makes
Ski boots sole were reversed engineering after they broke off.
Printen in 80% infill ABS, and lasted for about 3 weeks before i had to replace them.
Although the ski shoe was quite old, perhaps some of you might have the same problem?
Designed and printed by https://www.mtb3d.com/
Printen in 80% infill ABS, and lasted for about 3 weeks before i had to replace them.
Although the ski shoe was quite old, perhaps some of you might have the same problem?
Designed and printed by https://www.mtb3d.com/
MTB3D veröffentlicht auch auf
37 zusätzliche Modelle auf 2 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
