Thingiverse

Ski Wall Mount

by Jmotsay

16 Downloads

9 Likes

0 Makes

Simple ski mount - opening is just under 3/4" wide (.72 inches). Print time was about 7 hours at 60mm/sec

You will need 1, maybe 2, drill bit extensions to place the screw in the top hole!

gravity mount ski skiing skis wall wall mount

Source

Thingiverse

What you need to print this: Intermediate Low confidence

Single piece Hardware needed

Supports 1/3

Assembly 0/3

Settings 1/3

Bed size 0/3

Post-process 1/3

Printer

FDM / FFF

File format

STL

Material

PLA

Est. print time

7 h

Post-processing

Hardware

Software

Cura, PrusaSlicer, or similar

No ratings yet

No comments yet – be the first!

Similar Models

6 Suggestions

Ski Wall Mount

Similar Models

Add to Collection