Thingiverse
Ski Wall Mount
por Jmotsay
16
Descargas
9
Likes
0
Makes
Simple ski mount - opening is just under 3/4" wide (.72 inches). Print time was about 7 hours at 60mm/sec
You will need 1, maybe 2, drill bit extensions to place the screw in the top hole!
You will need 1, maybe 2, drill bit extensions to place the screw in the top hole!
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
