Thingiverse
skyzone 3d mount
von _tj_
5
Downloads
4
Likes
0
Makes
This will be a Quanum Trifecta mount for the Skyzone 3d Camera
This is intended to replace the top section of the gopro mount.
It will use the Gopro bottom mount, anti vibration rubbers, and this mount will go on the top of them.
I have built in a slight up angle.
WARNING.
It does seem a little narrow once printed.
But fits great once all 4 anti vibration balls have been attached.
This is intended to replace the top section of the gopro mount.
It will use the Gopro bottom mount, anti vibration rubbers, and this mount will go on the top of them.
I have built in a slight up angle.
WARNING.
It does seem a little narrow once printed.
But fits great once all 4 anti vibration balls have been attached.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!