Thingiverse
Sliding Spice Rack 200
por jonbourg
56
Descargas
57
Likes
0
Makes
This is the third sliding spice rack in a series. This version is 200mm wide.
The 100mm version is here https://www.thingiverse.com/thing:3402049
The 125mm version is here https://www.thingiverse.com/thing:3461574
The 150mm version is here https://www.thingiverse.com/thing:3415937
You have to put the top rail on before installing in the cabinet. Slide the rail all the way forward and put in the screws. I used #6 wood screws 1/2 inch long. The basket is glued onto the top rail. I use an acrylic glue (SCIGRIP 16) that IMHO is better than super glue for PLA. It has some nasty chemicals in it though. It just requires careful application and good ventilation. Gloves are also recommended.
Print with 3 walls and 25% to 50% infill. No support needed.
The 100mm version is here https://www.thingiverse.com/thing:3402049
The 125mm version is here https://www.thingiverse.com/thing:3461574
The 150mm version is here https://www.thingiverse.com/thing:3415937
You have to put the top rail on before installing in the cabinet. Slide the rail all the way forward and put in the screws. I used #6 wood screws 1/2 inch long. The basket is glued onto the top rail. I use an acrylic glue (SCIGRIP 16) that IMHO is better than super glue for PLA. It has some nasty chemicals in it though. It just requires careful application and good ventilation. Gloves are also recommended.
Print with 3 walls and 25% to 50% infill. No support needed.
jonbourg también publica en
5 modelos adicionales en 1 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
