Slim minimalist wallet

This is a minimalistic Wallet inspired by The Ridge.
It can hold about 10 cards, depending on the rubber band you are using.

Materials:
- 4 Screws
I made the holes just 2mm, so that you can drill them out for your needs
- 2 Strips of Rubberband with a maximum width of 31mm
-1 175mm
-1 31mm
- Superglue

Printed Parts:
- Top
- Bottom
- 2x Cover

Introduction:
Sew the long piece of rubberband together to get a ring. The smaller one ist also sewed to the large one as shown in the picture, to fit the grove on the 3d printed part. I put some superglue on the connection of the large piece, to give it some extra strength. Put the Top and Bottom together and strap the Rubberband over it. Glue and screw the Covers on both Top and Bottom.
Done!

Enjoy printing