Thingiverse
Small locking clasps
par MikeTitor
119
Téléchargements
117
Likes
0
Makes
Simple to print clasp. Designed for 550 4mm paracord projects but really can be used for just about anything.
You will need to heat up the male end and bend the thumb tab up. With PLA I use warm tap water, make the bend, then run it under cold to set it into place. You only need to bend the tab up enough so the bottom of the tab is just over the top of the male part of the clip.
The base design is 40mm long by 22mm wide when connected.
The new V2 is smaller measuring 32mm long by 18mm wide when connected.
Updated the female models orientation to further reduce support material.
You will need to heat up the male end and bend the thumb tab up. With PLA I use warm tap water, make the bend, then run it under cold to set it into place. You only need to bend the tab up enough so the bottom of the tab is just over the top of the male part of the clip.
The base design is 40mm long by 22mm wide when connected.
The new V2 is smaller measuring 32mm long by 18mm wide when connected.
Updated the female models orientation to further reduce support material.
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
