Slicer Discord
Small Quadcopter – 3D-Druckmodell von Thingiverse Thingiverse

Small Quadcopter

von gdlzsilip
13 Downloads
11 Likes
0 Makes
Zum Modell
This is a small 180 size quadcopter. The flying controller is a Crius MWC board, which can use 8 motor. I used MultiWII v2.3 firmware. The flying weight is 420g. It is a very fast quad, because the four motor has ~2000g power. The battery is a two cell LiPo 1200mAh, the flying time ~6 min.

Electrical parts:
Flying controller : http://www.dx.com/p/crius-mwc-multiwii-se-v2-5-version-multi-copter-4-axis-main-flight-control-board-blue-227394#.V8poyvmLTIU
Motors : http://www.dx.com/p/4-x2804-2280kv-cw-ccw-brushless-motor-4-15a-esc-2-pairs-of-6045-3-leaf-nylon-propeller-set-382471#.V8pqlvmLTIU
RC system : http://www.dx.com/p/flysky-fs-t6-2-4ghz-6-ch-2-9-lcd-tx-transmitter-rx-receiver-radio-control-system-black-8-x-aa-178448#.V8pq2PmLTIU
Firmware : http://www.multiwii.com/wiki/index.php?title=Main_Page#Software
Quelle
Thingiverse
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Nylon
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen