MakerWorld
Other Toys & Games
Zum Modell
Small switch fidget
39
Downloads
11
Likes
23
Makes
This very tiny fidget switch is fun to use, and easy to print. It is print in place and you can make it on pretty much any 3D printer. It's about a fifteen minute print and takes less than two and a half grams of filament to print one.It is very important that you have good bed adhesion before printing this. This design has very thin areas that will come off the printer plate very easily. If you try to print this and it fails because you didn't wash your plate, please don't leave a bad review. You can also add a brim in Bambu Studio if you want.Boost Me
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
