Small Table Catapult

A small catapult that was inspired by a thing:1763518
I found out that that thing tends to break in half and lose a lot of springyness.

So I made myself a custom small catapult (and some low-cost ammo as well)
It's made from two parts which you just combine together (better if glued)
Printed as a small rectangle.

Printer settings that I found as just fine:
(classic PLA)
- layer height: 0.2mm
- wall thickness: 1mm
- infill: 15%
- top/bottom: 1mm
- NO supports
- Adhesion type: skirt / 3 lines / 3mm

(build 2+ sets in different colors with different color ammo for the most fun)