Thingiverse
Engineering
Zum Modell
Small Threaded box
1
Downloads
1
Likes
0
Makes
These two make up a small and probably useless little box with a screw on lid.
It was done to see if I could:
A) make a thread inside and out on things in CAD
B) see how well it prints.
It came out OK to be honest.
I had to use a vice and a pair of pliers to screw it in the first time to clean the thread up, but after a few goes it's a nice fit.
It was done to see if I could:
A) make a thread inside and out on things in CAD
B) see how well it prints.
It came out OK to be honest.
I had to use a vice and a pair of pliers to screw it in the first time to clean the thread up, but after a few goes it's a nice fit.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
