Thingiverse
Smallish hinge
von kwg08
12
Downloads
11
Likes
0
Makes
I needed a small hinge. Here it is.
Assembled, it measures about 31 mm x 16.5 mm. The round part is about 4 mm thick. And the flat about 2 mm.
Use a piece of 1.75 filament as a pin.
It presses in slightly tight. So if it's non critical you could get away with no glue or any thing.
What I did was to cut the pin a tad long. Not much, 1 to 2 mm. Then I heated the corner of a razor blade and melted the pin to the hinge. Just use the corner of the blade so you don't melt the two halves together.
"THE BEER-WARE LICENSE" (Revision 42):
https://www.thingiverse.com/kwg08/ wrote this file.
As long as you retain this notice you
can do whatever you want with this stuff (for non profit uses only.)
If we meet some day, and you think this stuff is worth it, you can buy me a beer in return.
Assembled, it measures about 31 mm x 16.5 mm. The round part is about 4 mm thick. And the flat about 2 mm.
Use a piece of 1.75 filament as a pin.
It presses in slightly tight. So if it's non critical you could get away with no glue or any thing.
What I did was to cut the pin a tad long. Not much, 1 to 2 mm. Then I heated the corner of a razor blade and melted the pin to the hinge. Just use the corner of the blade so you don't melt the two halves together.
"THE BEER-WARE LICENSE" (Revision 42):
https://www.thingiverse.com/kwg08/ wrote this file.
As long as you retain this notice you
can do whatever you want with this stuff (for non profit uses only.)
If we meet some day, and you think this stuff is worth it, you can buy me a beer in return.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
