Thingiverse
Smart cable clamp
von insane78
123
Downloads
100
Likes
0
Makes
This is a clamp for cable management.
I printed it with zortrax m200 and makerbot replicator 2, using pla, petg and abs.
I think petg is better and much strong than others.
Printed at 190 microns, 50% infill honeycomb, with raft (maybe not needed)
Print the body using supports!
Hope this is useful.
Bye
I printed it with zortrax m200 and makerbot replicator 2, using pla, petg and abs.
I think petg is better and much strong than others.
Printed at 190 microns, 50% infill honeycomb, with raft (maybe not needed)
Print the body using supports!
Hope this is useful.
Bye
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
