smart home pushbutton light switch replacement

These files plus an esp32, ESPHome, two rotary encoders, and some 9mm mother-of-pearl insert discs (available on etsy) will allow you to make a fake wall switch that holds low-voltage 'drive by wire' remote switches for dimmers that can be controlled with Home Assistant.


DO NOT PUT THESE IN A WALL BOX WITH MAINS CURRENT. THESE ARE ONLY FOR A LOW-VOLTAGE ONLY WALL BOX.

DISCLAIMER: you assume your own risk for working with electricity. If you don't know what you are doing, don't do this. DO NOT WORK WITH MAINS VOLTAGE if you are untrained, it can kill you. Designer is not responsible if you use this in a dangerous manner. Designer is not responsible for any injury, damage, or death if you use these 3d prints. You agree to indemnify and hold the Designer (and its agents) harmless, including costs and attorneys’ fees, from any claim or demand. BY USING THESE PRODUCTS, YOU ACCEPT ALL RESPONSIBILITY, RISK, LIABILITY, AND DAMAGES ARISING OUT OF DEATH, DAMAGE, FIRE, OR PERSONAL INJURY RESUL