Smoke Case

I designed this cigarette case to be a little thinner than the other one. It can be printed without a CFS, but it can be a little tricky. In order to print without the CFS you have to print the files separately, but make sure they are aligned in the same spot on the build plate, print the logo first, and then leave the logo on the build plate and print the case over top of it. The logo is only two layers thick when printed at .2 layer height and there should be no problem printing the case on top of it as long as the models are aligned properly.The case requires 2 magnets, 5x5x5 mm cubed, an elastic, some glue, and a piece of filament for the hinge.