Thingiverse
SNAP DICE
door vikingfabian
342
Downloads
251
Likes
0
Makes
Snap-dice: Print the faces and center separately, and then snap them together. No glue needed. 17mm wide.
Each die has 1 mid and 6 faces.
All models already has pre-made supports and rafts.
Layer height 0.2mm
40% infill gives about the same weight as a retail die. Go up to 80% for some extra weight.
The symbols will get the best contrast if the center is of a darker color than the faces.
Content
Blank (use boolean>difference in a 3d modelling software to make your own dice)
Numbers: 0 to -3, 1 to 12, 16, 20, 25, 32, 50, 64
D3: three sided dice
Each die has 1 mid and 6 faces.
All models already has pre-made supports and rafts.
Layer height 0.2mm
40% infill gives about the same weight as a retail die. Go up to 80% for some extra weight.
The symbols will get the best contrast if the center is of a darker color than the faces.
Content
Blank (use boolean>difference in a 3d modelling software to make your own dice)
Numbers: 0 to -3, 1 to 12, 16, 20, 25, 32, 50, 64
D3: three sided dice
vikingfabian publiceert ook op
1 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
