Thingiverse
Snapmaker J1 Pi Camera Mount
door DeSkwared
0
Downloads
3
Likes
0
Makes
A Pi camera mount designed for the Snapmaker J1/J1s. This mount used the factory, threaded hole on the rear, left side, in which the OEM attached a plastic cable clamp. Remove the clamp, and flatten the ribbon cable against the rear of the printer frame. Install this mount by using a M3x12 (or longer) screw, utilizing the same hole. This is designed for the left side only.
Lower the bed to install. Once installed, manually raise the print bed as high as it will go and adjust the pivot to point the camera toward the center of the bed without interfering with the bed movement. The arm can also be angled slightly, to get the best fit. When properly adjusted, the camera will sit INSIDE the metal bed frame, as depicted in the picture. It should be close to level with the nozzles. You can easily route the ribbon cable through the included guide arm, and then between the printer shell's rear plate and the black steel frame (I find it easier to route it from the Pi to the camera, rat
Lower the bed to install. Once installed, manually raise the print bed as high as it will go and adjust the pivot to point the camera toward the center of the bed without interfering with the bed movement. The arm can also be angled slightly, to get the best fit. When properly adjusted, the camera will sit INSIDE the metal bed frame, as depicted in the picture. It should be close to level with the nozzles. You can easily route the ribbon cable through the included guide arm, and then between the printer shell's rear plate and the black steel frame (I find it easier to route it from the Pi to the camera, rat
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
