Thingiverse
Snapmaker Pi Camera Mount & Holder
von mellotanica
0
Downloads
0
Likes
0
Makes
Slightly modified original model to reduce overhangs to the bare minimum, the bracket part might still need supports to properly print the inside of the mounting ring, but a bit of file work can fix a wrong print afterwards as well
Also added an extra long arm variant for bigger 3d printers and a redesigned mount base with fitting measures for Snampaker A models mounting holes and groves on both inner sides to allow for mounting on both right and left sides of the print bed
Also added an extra long arm variant for bigger 3d printers and a redesigned mount base with fitting measures for Snampaker A models mounting holes and groves on both inner sides to allow for mounting on both right and left sides of the print bed
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
