Snapmaker U1 Double sided Feeder bracket - LEFT

Due to limited space with my set up, i wanted to have both feeder on the Left side of the printer. The bracket uses the same feeder attachment, without having to unplug existing auto feeder. A 60cm (3 x 20cm) extension cable is need to move the auto feeder from one side to the other. The locking leveller is designed with a 0.2 gap, so give it a good push to ‘break’ the weak connection. Then it should move the leveller freely. Both auto feeders attach to the bracket and lock as they would to the printer. designed with a 6mm gap to allow to work with @ken830 Snapmaker U1 PTFE Adapter (M6, M10, ECAS04) model (https://makerworld.com/en/models/2176077-snapmaker-u1-ptfe-adapter-m6-m10-ecas04#profileId-2360959)But i have seen other people use other designs, there is a 6mm gap between the two feeders, so any design 3mm wall thickness or less should work. Note - Two of the 4mm OD PTFE pipes will now be to short (going from the feeder to the back of the printer) and will require to be replaced f