Thingiverse

Sneaky Button "Latch"

door PartayPat

150 Downloads

154 Likes

0 Makes

See it in action here: https://youtu.be/wiV-4QnRMTo

I recently built a cabinet to house my 3d printer with a drawer and cupboard compartment beneath it. I made it so the front of the drawer/cupboard door sit flush with the front of the cabinet. Of course I could have just put a handle on it but that's too easy right. Also I have a baby on the way so wanted to make it harder for them to get in.

So I designed this method of opening the flush drawer with a sneaky side button. A push of moderate force will pop the door open just enough to get your thumb in and fully open it.

You will need a screw about 4mm dia and 20mm long to hold the lever and a 7mm drill bit to make the hole. My cabinet is made out of 18mm ply. If your's is thicker you will need to extend the poker/button to fit.

To drill the holes:
- measure and mark where the inside of door will be
- measure 11mm from side where button will be and scribe line
- place lever about 1mm back from inside door line to allow

button cabinet childproof childproofing childsafe cupboard Cupboard Door door drawer drawers flush handle Hidden hidden compartment keyless kid proof latch lever Lock open button cabinet childproof childproofing childsafe cupboard Cupboard Door door drawer drawers flush handle Hidden hidden compartment keyless kid proof latch lever Lock open

Bron

Thingiverse

Wat je nodig hebt om te printen: Gemiddeld Lage betrouwbaarheid

Eendelig Hardware nodig

Supports 1/3

Montage 0/3

Instellingen 1/3

Bedgrootte 0/3

Nabewerking 1/3

Printer

FDM / FFF

Bestandsformaat