SNES Reset Insert

I noticed my old US SNES was powering on to a black screen. When I toggled the power switch the screen would flicker for a brief moment. After taking the top case off I tried it again, and mysteriously the game booted. I put the cover back on and the black screen came back.

I noticed the little white insert for the reset button cylinder part was resting on the reset button on the motherboard. Not even pressing fully. I created this model to with similar dimensions but just a shorter cylinder part, and it fixed my SNES.

IMPORTANT:
This model must be printed on its side (see pic) with tree supports. If you print upright the thin clips will just snap off.

The fit is tight initially but it works great once in position.