Thingiverse

SNES Zero

von robertguy

229 Downloads

204 Likes

0 Makes

This is my first 3d print project :).

It uses a raspberry pi zero, running retropie.

Most of the inspiration for this came from Adafruit's PiGRRL and
Sudomod's Game Boy Zero. While designing this, I wanted to keep the look and feel of the classic SNES controller.

My google photo album with all the pics while designing/building it.
https://goo.gl/photos/DuyE2tGNVcjDhsfM6

parts:
- Raspberry Pi Zero
- 3.5in tft screen
- 10 x 6mm tactile switches
- 2 x 12mm tactile switches
- adafruit PowerBoost 1000c
- Lithium Ion Polymer Battery - 3.7v 2500mAh
- Adafruit Mono 2.5W Class D Audio Amplifier
- 8 ohm speaker
- IOGEAR 4-Port USB 2.0 Hub
- Panel Slide Switch
- 50k ohm Wheel Potentiometer 16 x 2mm
- 5-Pin Stereo 3.5mm Socket Audio Connector
- PCB Boards
- audio filter: 10uF cap, .033uF cap, 150 ohm resistor, 270 ohm resistor
- case screws: 2 x #4 -40 x 3/4" screw & nut
- buttons screws: 6 x #2 -56 x 3/8" screw & nut

UPDATE(12/18/16): Just uploaded new butt

adafruit diy electronics Gameboy gaming handheld Handheld Game Device NES Pigrrl Raspberry Pi Raspberry Pi Zero retro retropie SNES adafruit diy electronics Gameboy gaming handheld Handheld Game Device NES Pigrrl Raspberry Pi Raspberry Pi Zero retro retropie SNES

Quelle

Thingiverse

Was du zum Drucken brauchst: Mittel Niedrige Konfidenz

Einteilig Hardware nötig

Supports 1/3

Zusammenbau 0/3

Einstellungen 1/3

Druckbett 0/3

Nachbearbeitung 1/3

Drucker

FDM / FFF

Dateiformat